3D Printer Simulation with MiniMax M3

Step-by-step

1. Open MiniMax M3 and enter build mode in open code
2. Select the 3D printer simulation test
3. Adjust the layer height parameter using the slider
4. Select a shape to print, such as a circle or triangle
5. Observe the layer-by-layer generation and the spool movement
6. Use the reset function to clear the build plate for a new test

Options

• Set layer height to the maximum value for thick layers
• Set layer height to the smallest possible value for fine detail
• Switch between different geometric shapes like circles and triangles

Watch out for

• Increasing layer height significantly can make the model look 'funny' or obscure
• The filament spool may spin in an incorrect direction during the simulation

Tips

• Run parallel tests in the background to save time when showcasing multiple results
• Test the visual results thoroughly before concluding the quality, as oddities like 'ghosting' can occur due to material settings

Highlights

“This is a very good-looking model. Some of the printing had a bit of oddity to it, but aside from that... the model was done well.”